-
Standard phillips screws for 500 Series racks and modules, 24 pack
-
PSU 15VDC - 100-240V Switching for Radial products, International (NEW 2020)
-
Thumbscrews for 500 Series racks & modules, 12 screws & washers
-
Flanged adaptor for mounting standard size Radial Dls to any surface
-
Flanged adaptor for mounting small size Radial Dls to any surface
-
Load correction device for magnetic pickups, compact & light weight
-
Rack adaptor for SA series, Firefly, Prodigy - holds 1 or 2 in a single 19" space
-
PSU 500mA power supply for PowerStrip, Cube, JDV MKV, 4-pin XLR
-
Line level isolator, passive 1 channel balanced with Eclipse transformer
-
Compact active DI for acoustic guitar & bass, 48V phantom powered
-
Compact passive DI for bass & keyboards w/ stereo to mono mix
-
Combination buffer and 2x9V to 15V converter for Tonebones
-
Compact active DI for piezo pickups, low-cut filter, 48V phantom
-
19" Rack mount power conditioner/surge supressor, 11 outlets, 6pc carton*
-
4ch cat-5 mini breakout box to XLR-M tails, uses shielded cat-5
-
4ch cat-5 mini breakout box to TRS 1/4" tails, uses shielded cat-5
-
4ch cat-5 mini breakout box to XLR-F tails, uses shielded cat-5
-
Compact stereo DI for computers w/ attached cable, stereo or mono out
-
ABY switcher w/LEDs, true-bypass, transformer isolation & tuner out
-
Instrument selector w/LEDs, true-bypass with trim level control
-
Latching footswitch toggles two XLR inputs to one XLR output
-
Latching footswitch toggles one XLR input to two XLR outputs
-
Momentary footswitch toggles dynamic mic from PA to intercom
-
Rack adaptor houses up to 4 Radial DI boxes in a single 19" space
-
Passive DI for AV with stereo-to-mono mix, RCA, 35mm and XLR inputs
-
Mic splitter, passive, 1 input, 2 direct outs & 1 Eclipse isolated output
-
Compact stereo isolator for bal/unbalanced signals, passive
-
Wall-mount stereo DI, passive, fits in single gang receptacle
-
Two channel 48V phantom power supply for mics and active DI boxes
-
2 channel stereo to mono mixer, passive, TRS & XLR inputs, XLR out
-
Momentary footswith with active (LED) or passive circuit selector
-
Studio Guitar Interface, Replacement part - RX only (must be used with TX)
-
Studio Guitar Interface, Replacement part - TX only (must be used with RX)
-
Rack adaptor houses up to 8 Radial DI boxes in two rack 19" spaces
-
Effects loop controller w/LEDs, true-bypass with two discrete loops
-
19" Rack mount power conditioner/surge supressor, LED Lighting, 6pc carton*
-
Balanced +4dB to -10dB unbalanced passive converter, voice range
-
Passive DI for AV with level control, 2 channels with mono merge
-
Acoustic instrument preamp w/low cut and notch filter, built-in Radial DI*
-
ABY switcher, active class-A w/ Drag Control, phase rev & isolated out
-
Mic signal booster, class-A fet with 25dB gain, load adjust and filter
-
Guitar distro with 1x4 mono or 2x2 stereo routing w/ isolated outputs*
-
Dual input guitar mixer with insert loop to blend in effects*
-
Guitar amp simulator with 3 amp settings and balanced DI out*
-
Active DI for acoustic guitar & bass, extra headroom & high-pass filter
-
Passive DI for acoustic guitar, bass and keyboards - Industry standard
-
Guitar amp DI with speaker emulation & reactive load, phantom powered
-
Active class-A Reamper, dual output with level control & polarity reverse
-
Line splitter, passive, 1 input, 1 direct out & 1 Jensen Iso output with trim
-
Active -10dB to +4dB stereo line driver with transformer isolated inputs
-
Mic splitter, passive, 1 input, 2 direct outs & 1 Jensen isolated output
-
Active DI for orchestra, optimized for piezo and magnetic pickups
-
4ch receiver, balanced outs, line-level transformers, uses shielded cat-5
-
4ch transmitter, balanced i/o, line-level transformers, uses shielded cat-5
-
Amp selector with up to 4 outputs, isolated with 180° pol reverse*
-
8ch receiver, 19" rack mount, with balanced XLR-M. Uses sheilded cat-5/6
-
8ch transmitter, 19" rack mount, with balanced XLR-F. Uses shielded cat-5/6
-
Balanced AB wireless signal router, may be remotely controlled
-
Digital USB DI for laptops, 24/96 with heapdhone amp & isolated outs
-
Acoustic instrument preamp w/parametric EQ and built-in Radial DI
-
Phantom Power supply and footswitch toggles condensor mic between two outputs
-
Balanced +4dB to -10dB unbalanced passive stereo converter, full range, Jensen
-
Remote footswitch controller for JX44 for channel select and muting
-
Mic splitter, passive, 1 input, 1 direct out & 2 Jensen isolated outputs
-
Line splitter, passive, 1 input, 1 direct out & 2 Jensen isolated outputs
-
Studio Guitar Interface, TX & RX, extends cable to 100 meters (300') without loss
-
Line level isolator, passive 2 channel balanced with Jensen transformers
-
Effects loop interface connects guitar pedals to the recording system
-
Effects loop interface connects guitar pedals to the recording system
-
Studio talkback with built-in mic, external mic input, and program input
-
Class-A Reamp with two isolated outputs & adjustable level controls
-
Head switcher for 2 tube (valve) guitar amps, Slingshot remote input
-
4ch receiver, balanced outs, mic-level transformers, uses shielded cat-5
-
4ch transmitter, balanced i/o, mic-level transformers, uses shielded cat-5
